P.J. Flooring

What should I expect?

Admin — Mon, 02 Jan 2017 12:59:20 +0000

The final look will depend largely on the coating selected. While you can be confident of a hard wearing surface and attractive finish, there are some other unavoidable factors which you may need to consider.

As with any sort of renovation or maintenance work, a dusty environment is normal. Although modern floor coating equipment incorporates dust collection, it’s still virtually impossible to eliminate dust completely.

Because the sanding process only removes a fine top layer, any deep cuts or gouges in the timber, either naturally occurring or man made, may not be completely removed. Restoration prior to coating can provide a solution.

The same applies to deeply entrenched stains which may also be difficult to remove completely.

Heavy sanding equipment can leave light swirl marks in the timber which may be highlighted by fluorescent lighting or down lights. However, this is easily avoided with appropriate lighting choices.

Finally, its only normal for there to be slight variations in colour and grain between new and old boards.

What is the process?

Admin — Mon, 02 Jan 2017 12:40:27 +0000

Nails will be punched and filled; end joins, knots and parquetry will also be filled. The gaps between boards are not normally filled, to allow for expansion and compression of the wood. If filled, this process would cause cracking.

After this, a coating is applied which will enhance the flooring in your home and protect it for many years to come given the correct maintenance.

Slight variations and imperfections can occur as no two natural timbers are alike. Therefore, achieving a ‘furniture finish’ is virtually impossible. However, these ‘imperfections’ simply add character to your floor.

What are some of the colors that are available?

Admin — Mon, 02 Jan 2017 12:36:14 +0000

Here are some of the colors available, for more options:

How do I prepare for my new floor?

Admin — Mon, 02 Jan 2017 12:28:53 +0000

If you’re having other work or maintenance done in your home, it’s best to have this completed before work begins on your floor.
Excessive traffic and other works may also bring contaminants onto the floor which will affect the appearance and finish. At worst, this may necessitate re-sanding and re-coating.
New carpets should be laid after the floor has been finished. The last coat of paint on skirting boards should also be left until afterwards.
Prepare a clean and unobstructed site. All furniture must be removed curtains covered and any vents or draft areas sealed to prevent dust entering. Dusty areas, fixtures and fittings should all be cleaned before work commences.
Silicone or silicone based products on the floor, such as hairspray, furniture polish and fly spray, can cause subsequent levels of polyurethane coating to be rejected. Clean the floor as thoroughly as possible first.
All electrical and gas appliances should be switched off, including pilot lights.
Arranging alternative accommodation will allow the floor to dry thoroughly overnight.
Full curing of the floor will take up to 14 days so do not put down rugs during this time as they have abrasive backings.